Switch off ignition and disconnect a wire of "weight" from the rechargeable battery.
Chalk, marker or paint note the direction of rotation of a poliklinovy belt. If at installation poliklinovy the belt rotates in other party, it can lead to its destruction.
Release cars till 2001
Weaken a tension and take off a belt from pulleys, since a pulley of a bent shaft. When replacing a belt of the drive of the pump of the amplifier of steering previously it will be required to take off a conditioner compressor drive belt.
Fig. 2.15. An arrangement of a poliklinovy belt on engine pulleys: And — it is correct; In — it is wrong
After replacement of a belt check that the belt is correctly located on pulleys of the engine
Adjust a belt tension.
Release cars since 2001
Fig. 2.16. Weakening of a tension of a poliklinovy belt on cars since 2001: 1 – tension mechanism hexagon
Establish a cap key on a tension mechanism hexagon, turn it clockwise for weakening of a tension of a belt, and take off a belt from pulleys
. Slowly release the belt tension mechanism.
Again a key turn the tension mechanism clockwise and establish a new belt on engine pulleys, then smoothly release the tension mechanism.
Check that the belt is correctly located on pulleys of the engine
Connect a wire of "weight" to the rechargeable battery.