Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
   General information
   Technical characteristics
   Electric chains
   Check of the rechargeable battery
   Replacement of wires of the rechargeable battery
   Safety locks and relay
   Check and replacement of the relay of indexes of turn and alarm light system
   Check of system of charging
   Generator
   System of launch of the engine
   Replacement of the combined understeering switches
   Replacement of the lock and cylinder of the lock of ignition
   Removal and installation of switches of the dashboard
   Removal and installation of a combination of devices
   Check and replacement of the engine of a screen wiper
   Radio receiver and loudspeakers
   Replacement of the antenna
   Check and repair of a heater of back glass
   Replacement of lamps in headlights
   Adjustment of light of headlights
   Replacement of a headlight
   Sound signal
   Replacement of glow lamps
   Check of the drive of external rear-view mirrors
   Check of system cruise control
   Check of window regulators with the electric drive
   Check of system of the central blocking of locks
      System of remote control of the central blocking of locks
   Drive of the lifting and movable panel of a roof
   Safety cushions
Schemes of electric equipment


Toyota RAV4>> Electric equipment>> Check of system of the central blocking of locks>> System of remote control of the central blocking of locks
The system of remote control turns on the transmitter of remote control which sends the coded infrared signal to the receiver which operates system of blocking of locks. The transmitter also operates system of the precautionary alarm system which is turning on light and sound alarm systems.
If when pressing the button of the transmitter the red light-emitting diode does not light up, replace the battery of power supply of the transmitter. Due to the deterioration in parameters of the battery over time the radius of operation of the transmitter decreases.
For replacement of the battery with the small screw-driver divide the transmitter case, replace the battery, strictly observing polarity at installation of the new battery, then before click connect both halves of the case.