Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
   General information
   Technical characteristics
   Electric chains
   Check of the rechargeable battery
   Replacement of wires of the rechargeable battery
   Safety locks and relay
   Check and replacement of the relay of indexes of turn and alarm light system
   Check of system of charging
   Generator
   System of launch of the engine
   Replacement of the combined understeering switches
   Replacement of the lock and cylinder of the lock of ignition
   Removal and installation of switches of the dashboard
   Removal and installation of a combination of devices
   Check and replacement of the engine of a screen wiper
   Radio receiver and loudspeakers
   Replacement of the antenna
   Check and repair of a heater of back glass
   Replacement of lamps in headlights
   Adjustment of light of headlights
   Replacement of a headlight
   Sound signal
   Replacement of glow lamps
   Check of the drive of external rear-view mirrors
   Check of system cruise control
   Check of window regulators with the electric drive
   Check of system of the central blocking of locks
   Drive of the lifting and movable panel of a roof
   Safety cushions
Schemes of electric equipment


Toyota RAV4>> Electric equipment>> Replacement of glow lamps
       PREVENTION
Before replacement of the glow lamp remove a wire of "weight" from the rechargeable battery.
You remember: if the lamp just burned, it can be too hot.
Before replacement of the glow lamp check the corresponding electric chain and a safety lock.
Do not concern a glass flask of a lamp barehanded. Fatty traces on a lamp lead to darkening of a flask and a bystry exit of a lamp out of operation. Surely replace the failed lamps with lamps of the same type. Wipe the fatty spots arising on imprudence with a pure lint-free rag or alcohol

You make replacement of a lamp of the forward index of turn as follows.

Fig. 15.53. Arrangement of the screw of fastening of glass of the forward index of turn


Turn out the screw of fastening of glass of the forward index of turn and for access to a lamp take glass aside ( fig. 15.53 ).
Turn a cartridge with a lamp counterclockwise and remove it together with a lamp from the index of turn. Take a lamp from the boss.
You make installation of a lamp in the sequence, the return to removal.
Replacement of lamps in a back lamp on models till 2001
Open a door of the luggage compartment, turn out the screw and remove the decorative cover located under a back lamp.
Turn out 2 screws located in the lower part of a lamp, and separate a lamp from a body.
Turn a cartridge with the fused lamp counterclockwise and remove it together with a lamp from a back lamp. Take a lamp from the boss.
You make installation of a lamp in the sequence, the return to removal.
Replacement of lamps of back lamps on models since 2001
Uncover, located opposite to a lamp.

Fig. 15.54. Removal of the boss with a lamp from a back lamp on models since 2001


Turn a cartridge with a lamp counterclockwise and remove it together with a lamp from a back lamp ( fig. 15.54 ). Take a lamp from the boss.
You make installation of a lamp in the sequence, the return to removal.
Replacement of a lamp of the top stoplight
Open a door of the luggage compartment and remove the plastic cover closing the top stoplight.

Fig. 15.55. Removal of the boss with a lamp from the top stoplight


Turn a cartridge with a lamp counterclockwise and remove it together with a lamp from a back lamp ( fig. 15.55 ). Having pulled, take a lamp from the boss.
You make installation of a lamp in the sequence, the return to removal.
Replacement of a lamp of illumination of a combination of devices
Remove a combination of devices.
From a reverse side of a combination of devices turn the holder of a lamp counterclockwise and take him from a payment of a combination of devices.
Having pulled for a lamp, take it from the holder.
You make installation of a lamp in the sequence, the return to removal.
Replacement of a lamp of a forward plafond of illumination of salon

Fig. 15.56. Removal of glass of a forward plafond of illumination of salon


Edge of the screw-driver remove glass of a forward plafond of illumination of salon ( fig. 15.56 ).
Take a lamp from contact clips. For an exception of destruction of a lamp take it for side contacts
You make installation of a lamp in the sequence, the return to removal.
Replacement of a lamp of a lamp of illumination of registration plate

Fig. 15.57. Otzhatiye of clamps at removal of a lamp of illumination of registration plate


The thin screw-driver wring out 2 clamps and remove a lamp of illumination of registration plate from a door of the luggage compartment ( fig. 15.57 ).
Turn a cartridge with a lamp and remove it from a lamp of illumination of registration plate, then remove a lamp from the boss.
You make installation of a lamp in the sequence, the return to removal.
Replacement of a lamp of a fog light
Lift the car on the elevator.
For access to fog lights remove forward wheels and antisplash guards of arches of forward wheels.

Fig. 15.58. The boss's arrangement with a lamp of a fog light


Turn a cartridge and remove it from a fog light, then remove a lamp from the boss ( fig. 15.58 ).
You make installation of a lamp in the sequence, the return to removal.