Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
   General information
   Technical characteristics
   Electric chains
   Check of the rechargeable battery
   Replacement of wires of the rechargeable battery
   Safety locks and relay
   Check and replacement of the relay of indexes of turn and alarm light system
   Check of system of charging
   Generator
   System of launch of the engine
   Replacement of the combined understeering switches
   Replacement of the lock and cylinder of the lock of ignition
   Removal and installation of switches of the dashboard
   Removal and installation of a combination of devices
   Check and replacement of the engine of a screen wiper
   Radio receiver and loudspeakers
   Replacement of the antenna
   Check and repair of a heater of back glass
   Replacement of lamps in headlights
   Adjustment of light of headlights
   Replacement of a headlight
   Sound signal
   Replacement of glow lamps
   Check of the drive of external rear-view mirrors
   Check of system cruise control
   Check of window regulators with the electric drive
   Check of system of the central blocking of locks
   Drive of the lifting and movable panel of a roof
   Safety cushions
Schemes of electric equipment


Toyota RAV4>> Electric equipment>> Replacement of lamps in headlights
       PREVENTIONS
H7 glow lamps of elevated pressure can burst when replacing therefore these lamps should be replaced in gloves and goggles.
Do not concern a glass flask of a lamp barehanded. Fatty traces on a lamp lead to darkening of a flask and a bystry exit of a lamp out of operation. Surely replace the failed lamps with lamps of the same type. Wipe the fatty spots arising on imprudence with a pure lint-free rag or alcohol.

You make replacement of lamps as follows:
Open a cowl.
From a reverse side of a headlight disconnect the electric socket, previously having released a clamp.

Fig. 15.47. Removal of a rubber protective cover from a headlight


Pull a rubber protective cover back and remove it from a headlight ( fig. 15.47 ).
Turn a cartridge with a lamp counterclockwise and remove it from a headlight.
Having pulled, take a lama from the boss.
Insert a cartridge with a lamp into a headlight and turn it clockwise.
Establish a rubber protective cover and connect the electric socket.