Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
   General information
   Technical characteristics
   Electric chains
   Check of the rechargeable battery
   Replacement of wires of the rechargeable battery
   Safety locks and relay
   Check and replacement of the relay of indexes of turn and alarm light system
   Check of system of charging
   Generator
   System of launch of the engine
   Replacement of the combined understeering switches
   Replacement of the lock and cylinder of the lock of ignition
   Removal and installation of switches of the dashboard
   Removal and installation of a combination of devices
   Check and replacement of the engine of a screen wiper
   Radio receiver and loudspeakers
   Replacement of the antenna
      Removal of the antenna
      Installation of the antenna
   Check and repair of a heater of back glass
   Replacement of lamps in headlights
   Adjustment of light of headlights
   Replacement of a headlight
   Sound signal
   Replacement of glow lamps
   Check of the drive of external rear-view mirrors
   Check of system cruise control
   Check of window regulators with the electric drive
   Check of system of the central blocking of locks
   Drive of the lifting and movable panel of a roof
   Safety cushions
Schemes of electric equipment


Toyota RAV4>> Electric equipment>> Replacement of the antenna>> Installation of the antenna
You make installation of the antenna as follows.
On cars with the antenna installed on a roof install the antenna and fix by screws.
On cars with the antenna installed on a wing establish on it the holder of the antenna and fix it by a bolt, then establish an antenna core in the holder.
You make installation of the automatic antenna as follows:
Install the antenna under an arch of a wheel and fix by a bolt.

Fig. 15.43. At installation of a core of the automatic antenna teeths of a cable of the antenna have to be directed to a forward part of the car


Establish an antenna core in the holder of the antenna, so that teeths of a cable were directed to a forward part of the car ( fig. 15.43 ).
Turn a key in the ignition lock in position of LOCK, at the same time the antenna has to fall in the holder of the antenna.
Establish the basis of the antenna and fix it by a nut.
You make further installation of antennas of all types as follows:
Carry out an antenna wire behind a ware box to the radio receiver.
Install the radio receiver.
Establish a ware box.