Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
   General information
   Technical characteristics
   Electric chains
   Check of the rechargeable battery
   Replacement of wires of the rechargeable battery
   Safety locks and relay
   Check and replacement of the relay of indexes of turn and alarm light system
   Check of system of charging
   Generator
   System of launch of the engine
   Replacement of the combined understeering switches
   Replacement of the lock and cylinder of the lock of ignition
   Removal and installation of switches of the dashboard
   Removal and installation of a combination of devices
   Check and replacement of the engine of a screen wiper
   Radio receiver and loudspeakers
   Replacement of the antenna
      Removal of the antenna
      Installation of the antenna
   Check and repair of a heater of back glass
   Replacement of lamps in headlights
   Adjustment of light of headlights
   Replacement of a headlight
   Sound signal
   Replacement of glow lamps
   Check of the drive of external rear-view mirrors
   Check of system cruise control
   Check of window regulators with the electric drive
   Check of system of the central blocking of locks
   Drive of the lifting and movable panel of a roof
   Safety cushions
Schemes of electric equipment


Toyota RAV4>> Electric equipment>> Replacement of the antenna>> Removal of the antenna
You make removal of the antenna as follows.

Fig. 15.39. An arrangement of screws of fastening of the antenna installed on a roof


For removal of the antenna installed on a roof turn out 2 screws and separate the antenna from a body ( fig. 15.39 ).

Fig. 15.40. A reversing of a core of the antenna installed on a car wing



Fig. 15.41. A reversing of a nut of fastening of the basis of the antenna installed on a car wing


For removal of the antenna installed on a forward wing turn out an antenna core, then turn out a nut of fastening of the holder of the antenna and separate it from a body ( fig. 15.40 , 15.41 ).
You make removal of the automatic antenna as follows:
Turn a key in the ignition lock in the provision of "LOCK" and weaken nuts of fastening of the antenna.
Turn a key in the ignition lock in the provision of "ACC" and press the button of turning on of the radio receiver in AM range, at the same time the antenna will automatically start to situation at which it will be disconnected from the drive mechanism.
Separate an antenna core from the holder.
You make further removal of antennas of all types as follows.
On cars with the antenna installed on a wing lift the car on the elevator and remove a forward wheel.
On cars with the antenna installed on a roof for access to a wire of the antenna remove an upholstery of a forward rack.

Fig. 15.42. An arrangement of a bolt of fastening of the antenna installed on a car wing


On cars with the antenna installed on a wing from under an arch of a wheel turn out a bolt of fastening of the holder of the antenna ( fig. 15.42 ).
On cars with the antenna installed on a wing put forward fastening of the antenna in a wing and remove the condensing ring.
Remove the radio receiver and disconnect from it the antenna plug.
On cars with the antenna installed on a wing remove a ware box and extend an antenna wire.
On cars with the automatic antenna disconnect the basis of the antenna and a wire of the antenna from a gear cable of the engine.
 

Букмекерские конторы в россии на http://www.winline.ru.