Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
   General information
   Technical characteristics
   Electric chains
   Check of the rechargeable battery
   Replacement of wires of the rechargeable battery
   Safety locks and relay
   Check and replacement of the relay of indexes of turn and alarm light system
   Check of system of charging
   Generator
   System of launch of the engine
   Replacement of the combined understeering switches
   Replacement of the lock and cylinder of the lock of ignition
   Removal and installation of switches of the dashboard
      Switch of the alarm light system
      Switch of adjustment of provision of an external mirror
      Switch of a heater of back glass
      Dashboard illumination rheostat
   Removal and installation of a combination of devices
   Check and replacement of the engine of a screen wiper
   Radio receiver and loudspeakers
   Replacement of the antenna
   Check and repair of a heater of back glass
   Replacement of lamps in headlights
   Adjustment of light of headlights
   Replacement of a headlight
   Sound signal
   Replacement of glow lamps
   Check of the drive of external rear-view mirrors
   Check of system cruise control
   Check of window regulators with the electric drive
   Check of system of the central blocking of locks
   Drive of the lifting and movable panel of a roof
   Safety cushions
Schemes of electric equipment


Toyota RAV4>> Electric equipment>> Removal and installation of switches of the dashboard>> Switch of a heater of back glass
You make removal of the switch of a heater of back glass on models till 2001 as follows.
Using a screw-driver edge as the lever, separate the switch of a heater of back glass and take it from the dashboard.
Disconnect the electric socket, wring out a clamp and take the switch from a casing.
Removal of the switch
heater of back glass
on models since 2001
It is made as follows.

Fig. 14.51. An arrangement of screws of fastening of the central overlay of the dashboard on models since 2001


Turn out screws and remove the central slip from the dashboard (see fig. 14.51 ).

Fig. 15.25. Arrangement of screws of fastening of the control unit of a heater


Turn out screws and extend the control unit of a heater from the dashboard, then disconnect the electric socket from a back part of the switch (see fig. 15.25 ). Wring out a clamp and take the switch from the holder.
You make installation of the switch of a heater of back glass of both types in the sequence, the return to removal.