Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
   General information
   Care of a body
   Care of an upholstery and rugs
   Repair of insignificant damages of a body
   Repair of considerable damages of a body
   Service of hinges and locks
   Recommendations about replacement of a windshield and motionless glasses
   Removal and installation of a cowl
   Lock and cable of opening of the lock of a cowl
   Removal and installation of bumpers
   Removal and installation of forward wings
   Removal and installation of facing of the Radiator
   Removal and installation of the deflector of a ventilating grate
   Removal and installation of an upholstery of doors
   Doors
      Removal and installation of doors
      Adjustment of doors
      Removal and installation of the lock of a door
      Removal and installation of the external handle and cylinder of the lock of a door
      Removal and installation of the internal handle of the lock of a door
   Removal and installation of glasses of doors
   Removal and installation of window regulators
   Removal and installation of an external rear-view mirror
   Removal and installation of an internal rear-view mirror
   Door of the luggage compartment
   Removal and installation of the central console
   Removal and installation of elements of finishing of the dashboard
   Removal and installation of casings of a steering column
   Removal and installation of the dashboard
   Removal and installation of seats
   Adjustment of the lifting and movable panel of a roof
15. Electric equipment
Schemes of electric equipment


Toyota RAV4>> Body>> Doors>> Removal and installation of the external handle and cylinder of the lock of a door
You make removal of the external handle and cylinder of the lock of a door as follows:
Lift against the stop door glass, then remove an upholstery and a pylevlagozashchitny film from a door.
Not to scratch a paint and varnish covering of a door, paste on a door about the handle an adhesive tape.
Through an opening in the internal panel of a door release plastic clips and disconnect drafts from the external handle of a door and the cylinder of the lock.
Till 2001 further operate on models as follows:
– turn out bolts of fastening of the handle and remove from a door the external handle together with the lock cylinder;
– remove a clip and take the lock cylinder from the handle.
Since 2001 operate on models as follows:

Fig. 14.31. Removal of a cap from a door end face for access to the screw of fastening of the cylinder of the lock of a door on models since 2001


Fig. 14.32. Removal of the cylinder of the lock from a door on models since 2001


– remove a cap from a door end face, turn out the screw of fastening and remove the lock cylinder from a door ( fig. 14.31 , 14.32 );

Fig. 14.33. An arrangement of bolts of fastening of the external handle to a door on models since 2001


– from the inside of a door turn out a bolt and remove the external handle from a door ( fig. 14.33 ).
You make installation in the sequence, the return to removal.