Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
   General information
   Care of a body
   Care of an upholstery and rugs
   Repair of insignificant damages of a body
   Repair of considerable damages of a body
   Service of hinges and locks
   Recommendations about replacement of a windshield and motionless glasses
   Removal and installation of a cowl
   Lock and cable of opening of the lock of a cowl
   Removal and installation of bumpers
   Removal and installation of forward wings
   Removal and installation of facing of the Radiator
   Removal and installation of the deflector of a ventilating grate
   Removal and installation of an upholstery of doors
   Doors
   Removal and installation of glasses of doors
   Removal and installation of window regulators
   Removal and installation of an external rear-view mirror
   Removal and installation of an internal rear-view mirror
   Door of the luggage compartment
   Removal and installation of the central console
   Removal and installation of elements of finishing of the dashboard
   Removal and installation of casings of a steering column
   Removal and installation of the dashboard
   Removal and installation of seats
   Adjustment of the lifting and movable panel of a roof
15. Electric equipment
Schemes of electric equipment


Toyota RAV4>> Body>> Removal and installation of forward wings
       PREVENTION
Cars are equipped with security systems (SRS) including safety cushions and natyazhitel of seat belts. Before work about sensors of blow, the dashboard and a steering column disconnect at first negative, and then positive plugs from the rechargeable battery and wait 2 min. It will exclude unauthorized disclosure of safety cushions and operation of natyazhitel of seat belts which can put injuries.

You make removal of forward wings as follows:
Tighten the parking brake and block back wheels an emphasis.
Weaken nuts of fastening of a forward wheel.
Lift a forward part of the car and establish on support.
Remove a forward wheel.
Open a cowl.
On models till 2001 remove the panel located under a headlight.
On models since 2001 remove a front grille.
Remove a front bumper (see above).
Remove a headlight.

Fig. 14.12. An arrangement of clamps and screws (the lower clamps are not shown) fastenings of an antisplash guard of an arch of a forward wheel


Release clamps, turn out screws and remove an antisplash guard of an arch of a forward wheel ( fig. 14.12 ).
If the right wing is removed, remove the radio receiver antenna. At removal of the left wing remove a rack of support of a cowl in open situation.
Open a forward door and turn out the top bolt of fastening of a wing to a car body.
Turn out the lower bolt of fastening of a wing to a car body.

Fig. 14.13. An arrangement of a bolt of fastening of a wing available from under a wheel arch


Turn out the bolt of fastening of a wing available from under a wheel arch ( fig. 14.13 ).

Fig. 14.14. Arrangement of a bolt of fastening of a forward part of a wing


Turn out a bolt of fastening of a forward part of a wing ( fig. 14.14 ).

Fig. 14.15. Arrangement of bolts of fastening of the top part of a forward wing


Turn out 3 bolts of fastening of the top part of a forward wing ( fig. 14.15 ).
Remove a wing from the car, at the same time be careful not to scratch the body panel close to a wing.
You make installation in the sequence, the return to removal, taking into account the following:
Install a forward wing on the car, combine openings under screws and clamps and fix it.
At installation of a wing check that gaps between a wing and a cowl, and also between a wing and a forward door were uniform on all length.