Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
   General information
   Care of a body
   Care of an upholstery and rugs
   Repair of insignificant damages of a body
   Repair of considerable damages of a body
   Service of hinges and locks
   Recommendations about replacement of a windshield and motionless glasses
   Removal and installation of a cowl
   Lock and cable of opening of the lock of a cowl
   Removal and installation of bumpers
      Removal and installation of a front bumper
      Removal and installation of a rear bumper
   Removal and installation of forward wings
   Removal and installation of facing of the Radiator
   Removal and installation of the deflector of a ventilating grate
   Removal and installation of an upholstery of doors
   Doors
   Removal and installation of glasses of doors
   Removal and installation of window regulators
   Removal and installation of an external rear-view mirror
   Removal and installation of an internal rear-view mirror
   Door of the luggage compartment
   Removal and installation of the central console
   Removal and installation of elements of finishing of the dashboard
   Removal and installation of casings of a steering column
   Removal and installation of the dashboard
   Removal and installation of seats
   Adjustment of the lifting and movable panel of a roof
15. Electric equipment
Schemes of electric equipment


Toyota RAV4>> Body>> Removal and installation of bumpers>> Removal and installation of a front bumper
You make removal of a front bumper as follows:
Lift the car on the elevator.
Remove the lower antisplash guards.
Till 2001 further operate on models as follows:

Fig. 14.5. Front bumper of models 1996 and 1997 of years: 1 – screws; 2 – amplifier of a front bumper; 3 – arm; 4 – lamp of the index of turn; 5 – decorative cover; 6 – headlight; 7 – decorative cover; 8 – headlight; 9 – lamp of the index of turn; 10 – bumper; 11 – arm


Fig. 14.6. A front bumper of models from 1998 to 2001: 1 – decorative cover; 2 – bumper; 3 – cover of side extension of a bumper; 4 – headlight; 5 – lamp of the index of turn; 6 – lower arm; 7 – amplifier of a front bumper; 8 – side arm; 9 – side arm; 10 – lower arm; 11 – lower element of rigidity of a bumper; 12 – cover of side extension of a bumper; 13 – lamp of the index of turn; 14 – headlight; 15 – decorative cover


– turn out the screws fixing top and side parts of a bumper (fig. 14.5, 14.6) ;
– move a bumper forward, disconnect electric sockets from indexes of turn and remove a bumper from the car;
– if it is necessary to remove the amplifier of a front bumper and arms, previously remove headlights.
Since 2001 further operate on models as follows:
– turn out screws of the top fastening of facing of a radiator;
– reject facing a little forward and the screw-driver release clamps of the lower fastening of facing of a radiator and remove it from the car;

Fig. 14.17. An arrangement of screws (above) and clamps (in the bottom of) fastening of facing of a radiator on models since 2001


Fig. 14.7. Arrangement of screws of the top fastening and clamps of the lower fastening of facing of headlights


– turn out screws of the top fastening (the top shooters in fig. 14.17 ), release clamps (the lower arrows in fig. 14.7 ) the lower fastening and remove the panel of facing of headlights;

Fig. 14.8. Release of side clamps of fastening of the panel of facing of headlights


– pull facing forward and the screw-driver wring out side clamps (fig. 14.8) and remove facing of headlights from the car.
– from under the car turn out screws of the lower fastening of a bumper;

Fig. 14.9. Arrangement of screws of fastening of the lower side parts of a front bumper


– turn out screws of fastening of the lower side parts of a bumper (fig. 14.9) ;
– turn off a forward part of antisplash guards of arches of forward wheels;
– turn out the opened screws of fastening of a bumper to forward wings and remove a bumper from the car.
You make installation in the sequence, the return to removal.