Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
   General information
   Care of a body
   Care of an upholstery and rugs
   Repair of insignificant damages of a body
      Processing of scratches of a body
      Repair of dents of a surface of a body
      Hard putty and painting of a body
   Repair of considerable damages of a body
   Service of hinges and locks
   Recommendations about replacement of a windshield and motionless glasses
   Removal and installation of a cowl
   Lock and cable of opening of the lock of a cowl
   Removal and installation of bumpers
   Removal and installation of forward wings
   Removal and installation of facing of the Radiator
   Removal and installation of the deflector of a ventilating grate
   Removal and installation of an upholstery of doors
   Doors
   Removal and installation of glasses of doors
   Removal and installation of window regulators
   Removal and installation of an external rear-view mirror
   Removal and installation of an internal rear-view mirror
   Door of the luggage compartment
   Removal and installation of the central console
   Removal and installation of elements of finishing of the dashboard
   Removal and installation of casings of a steering column
   Removal and installation of the dashboard
   Removal and installation of seats
   Adjustment of the lifting and movable panel of a roof
15. Electric equipment
Schemes of electric equipment


Toyota RAV4>> Body>> Repair of insignificant damages of a body>> Repair of dents of a surface of a body
At deep cave-in of elements of a design of a body first of all try to curve a dent before the maximum approach to a normal form of a body. Body metal in the place of blow is exposed to a pulling therefore the complete recovery of an initial form is impossible. Alignment of a dent about 3 mm lower than the level of a surrounding surface is considered optimum. If there is an access to dent inside, it is necessary to correct accurately it the hammer with wooden or plastic brisk for what make the following.
Densely press the wooden whetstone suitable by the size from outer side of the corrected area. It is required for depreciation of blows of the hammer and prevention of a flexure of more extensive area.
If the dent is in that area of a body where access from a reverse side is complicated or impossible, drill several small openings in the deepest points of a dent, screw several screws self-tapping screws in them and extend a dent by means of flat-nose pliers for the acting heads of screws.
Remove paint from the damaged area and at distance of 20 mm around it.
The easiest to make it the wire brush or an emery paper got on the circle fixed in the electric drill.
After alignment of a dent apply on it a layer of hard putty, paint and polish.