Device and repair of Toyota RAV4 SUVs (Toyota RAV) - Removal and installation of tips of steering drafts-//

Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
   General information
   Technical characteristics
   Removal and installation of a steering wheel with a safety cushion
   Removal and installation of a steering column
   Removal and installation of tips of steering drafts
   Replacement of covers of the steering mechanism
   Removal and installation of the steering mechanism
   Removal and installation of the pump of the amplifier of steering
   Pumping of hydraulic system of the amplifier of steering
   Replacement of bolts of fastening of a wheel
   Wheels and tires
14. Body
15. Electric equipment
Schemes of electric equipment


Toyota RAV4>> Steering and running gear>> Removal and installation of tips of steering drafts
You make removal of tips of steering drafts as follows.
Tighten the parking brake and block back wheels an emphasis.
Weaken nuts of fastening of a forward wheel. Lift a forward part of the car and establish on support. Remove a forward wheel.

Fig. 13.10. An arrangement of the nut recorded by a pin, fastenings of a pin of the spherical hinge of a tip of steering thirst for a rotary fist


Take the forelock and weaken, but do not turn out completely, a nut of fastening of a pin of the spherical hinge of a tip of steering thirst for a rotary fist ( fig. 13.10 ).
Passatizhami or a wrench keep steering draft from a provorachivaniye and turn out a lock-nut of a tip of steering draft on several turns, then paint note the provision of the end of a tip on steering draft.

Fig. 13.11. Use of a stripper for expression of a pin of the spherical hinge of a tip of steering draft from a rotary fist


Stripper squeeze out a pin of the spherical hinge of a tip of steering draft from a rotary fist ( fig. 13.11 ).
Turn out a nut and remove a pin of the spherical hinge of a tip of steering draft from a rotary fist.
Turn out a tip of steering draft from steering draft.
You make installation of a tip of steering draft as follows:
Screw a tip of steering draft on steering draft to the mark put before removal.
Insert a pin of the spherical hinge of a tip of steering draft into a rotary fist. Tighten a lock-nut of a tip of steering draft.
Screw a nut of fastening of a pin of the spherical hinge of a tip of steering thirst for a rotary fist, tighten of 36 N • also install to m by its moment the new forelock. If the opening in a pin for the forelock does not coincide with grooves on a nut, tighten a nut (do not turn out) to situation until grooves on a nut are on one line with an opening.
Establish a wheel, screw nuts, lower the car and tighten nuts of fastening of a wheel.
Check and if necessary adjust the angles of installation of wheels.