Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
12. Suspension bracket
   General information
   Specifications
   Rack of a forward suspension bracket
   Dismantling and assembly of a depreciation rack
   Forward stabilizer of cross stability
   Lower lever of a forward suspension bracket
   Rotary fist and nave of a forward wheel
   Back stabilizer of cross stability
   Shock-absorber of a back suspension bracket
   Levers of a back suspension bracket
   Spring of a back suspension bracket
   Nave and bearing of a back wheel
      Removal
      Installation
13. Steering and running gear
14. Body
15. Electric equipment
Schemes of electric equipment


Toyota RAV4>> Suspension bracket>> Nave and bearing of a back wheel>> Removal
On all-wheel drive models weaken a nut of fastening of a shaft of the drive to a nave of a back wheel.
Block forward wheels an emphasis. Lift a back part of the car and establish it on support. Remove a wheel.
Remove the brake drum. On models with one leading bridge of release of 1996 and 1997 and all-wheel drive models till 2001 remove brake shoes, disconnect a cable of the parking brake from the protection cover of a back brake and disconnect a brake tube from the working brake cylinder.
On all-wheel drive models remove a wheel drive shaft.

Fig. 12.25. Otvorachivaniye of bolts of fastening of a nave to a back rotary fist


Through openings in a nave turn out four bolts (on models till 2001) or nuts (on models since 2001) fastenings of a nave to a back rotary fist ( fig. 12.25 ).
Remove a nave of a back wheel together with the bearing. On models with one leading bridge of release of 1996 and 1997 and all-wheel drive models till 2001 together with a nave remove the protection cover of a back brake. On models with one leading bridge of release from 1998 to 2001 repeatedly screw one of bolts for support of the protection cover of a back brake.
On models with one leading bridge of release of 1996 and 1997 and all-wheel drive models till 2001 it is possible to vypressovat the old bearing from a nave and to press new. This work needs to be performed at service station. On all other models the nave with the bearing is made as the uniform block, and at failure of the bearing it will be required to replace a nave assembled.
On models with one leading bridge of release since 2001 with ABS remove the rotation frequency sensor from an old nave and establish on a new nave.