Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
12. Suspension bracket
   General information
   Specifications
   Rack of a forward suspension bracket
   Dismantling and assembly of a depreciation rack
   Forward stabilizer of cross stability
   Lower lever of a forward suspension bracket
   Rotary fist and nave of a forward wheel
   Back stabilizer of cross stability
   Shock-absorber of a back suspension bracket
   Levers of a back suspension bracket
      Replacement of the top cross lever
      Replacement of the lower cross lever
      Replacement of the longitudinal lever
   Spring of a back suspension bracket
   Nave and bearing of a back wheel
13. Steering and running gear
14. Body
15. Electric equipment
Schemes of electric equipment


Toyota RAV4>> Suspension bracket>> Levers of a back suspension bracket>> Replacement of the longitudinal lever
Remove a spring.
Turn out bolts and remove arms of a brake tube and a cable of the parking brake from the longitudinal lever of a back suspension bracket.
Remove a nave of a back wheel together with the bearing. Remove from the longitudinal lever the protection cover of a back brake together with brake shoes and a soft wire fix on a body.

Fig. 12.24. An arrangement of the adjusting cam defining relative position of the longitudinal lever and an arm


Paint or marker note the provision of the adjusting cam defining relative position of the longitudinal lever and an arm ( fig. 12.24 ).
Turn out a hinged bolt and separate the longitudinal lever of a back suspension bracket from an arm.
Check a condition of the plug for lack of wear, stratification and hardening of rubber. If necessary replace the plug with service stations.
You make installation in the sequence, the return to removal, taking into account the following.
According to earlier put tags establish an adjusting cam of the longitudinal lever defining relative situation and an arm.
Before tightening of a hinged bolt of fastening of the longitudinal lever to an arm raise a jack a back part of the lever to install the lever in situation in which it has to be when the car costs on wheels.
In this position of the lever tighten all nuts and bolts of fastening of a back suspension bracket.
Check and if necessary adjust the angles of installation of back wheels.