Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
12. Suspension bracket
   General information
   Specifications
   Rack of a forward suspension bracket
   Dismantling and assembly of a depreciation rack
   Forward stabilizer of cross stability
   Lower lever of a forward suspension bracket
   Rotary fist and nave of a forward wheel
   Back stabilizer of cross stability
   Shock-absorber of a back suspension bracket
   Levers of a back suspension bracket
      Replacement of the top cross lever
      Replacement of the lower cross lever
      Replacement of the longitudinal lever
   Spring of a back suspension bracket
   Nave and bearing of a back wheel
13. Steering and running gear
14. Body
15. Electric equipment
Schemes of electric equipment


Toyota RAV4>> Suspension bracket>> Levers of a back suspension bracket>> Replacement of the top cross lever

Fig. 12.21. An arrangement of nuts of fastening of the top and lower cross levers to a back rotary fist on models till 2001


On models till 2001 remove the forelock, turn off a nut and separate a pin of the spherical hinge of the top lever from a back rotary fist ( fig. 12.21 ). If the pin of the spherical hinge does not separate manually, take it by means of a stripper.

Fig. 12.22. An arrangement of a bolt of fastening of the top lever to an arm on the longitudinal lever of a back suspension bracket on models since 2001


On models till 2001 turn off a nut and take a bolt of fastening of the top lever to an arm on the longitudinal lever of a back suspension bracket ( fig. 12.22 ).
Turn off a nut and take a hinged bolt of internal fastening of the top lever.
Remove the top cross lever from the car.
Check a condition of the lever. On it there should not be cracks and deformations. The plug should not have wear, stratification and hardening of rubber.
On models till 2001 check a condition of the spherical hinge of the top cross lever for what fix the lever in a vice. Reject against the stop in one and other party a pin of the spherical hinge, then screw a nut on a pin. A dynamometer key turn a pin of the spherical hinge (one turn for 2–4 c), and on the fifth turn measure torque of a provorachivaniye which has to be not less than 0,7 N • m. Otherwise replace the top cross lever.
You make installation in the sequence, the return to removal.