Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
12. Suspension bracket
   General information
   Specifications
   Rack of a forward suspension bracket
   Dismantling and assembly of a depreciation rack
   Forward stabilizer of cross stability
   Lower lever of a forward suspension bracket
   Rotary fist and nave of a forward wheel
   Back stabilizer of cross stability
      Removal
      Installation
   Shock-absorber of a back suspension bracket
   Levers of a back suspension bracket
   Spring of a back suspension bracket
   Nave and bearing of a back wheel
13. Steering and running gear
14. Body
15. Electric equipment
Schemes of electric equipment


Toyota RAV4>> Suspension bracket>> Back stabilizer of cross stability>> Removal
The back stabilizer of cross stability is installed on models since 2001
Block forward wheels an emphasis. Lift a back part of the car and establish it on support.

Fig. 12.16. Arrangement of a nut of fastening of draft of the stabilizer of cross resistance to the stabilizer


Turn off nuts of fastening of drafts of the stabilizer of cross stability ( fig. 12.16 ). At an otvorachivaniye of nuts of fastening of spherical hinges of draft of the stabilizer a six-sided key hold a pin of the spherical hinge from a provorachivaniye.

Fig. 12.17. An arrangement of nuts of fastening of the clips fixing the stabilizer of cross resistance to a car body


Turn out bolts of fastening of the clips with plugs fixing the stabilizer of cross resistance to a car body ( fig. 12.17 ).
Remove the stabilizer of cross stability from the car.
Remove basic plugs from the stabilizer and check their state.
Check a condition of spherical hinges of drafts of the stabilizer. For this purpose remove them from the car and fix in a vice (fig. 10). Reject against the stop in one and other party a pin of the spherical hinge, then screw a nut on a pin. A dynamometer key turn a pin of the spherical hinge (one turn for 2–4 c), and on the fifth turn measure torque of a provorachivaniye which has to be not less than 0,04 N • m. Otherwise replace draft of the stabilizer.
Wire brush clear stabilizer zones on which basic plugs are installed.