Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
12. Suspension bracket
   General information
   Specifications
   Rack of a forward suspension bracket
   Dismantling and assembly of a depreciation rack
   Forward stabilizer of cross stability
   Lower lever of a forward suspension bracket
   Rotary fist and nave of a forward wheel
      Removal
      Installation
   Back stabilizer of cross stability
   Shock-absorber of a back suspension bracket
   Levers of a back suspension bracket
   Spring of a back suspension bracket
   Nave and bearing of a back wheel
13. Steering and running gear
14. Body
15. Electric equipment
Schemes of electric equipment


Toyota RAV4>> Suspension bracket>> Rotary fist and nave of a forward wheel>> Installation
If the spherical hinge was removed from a rotary fist, establish it and fix by a nut, having tightened it the moment specified in specifications and record the forelock.
Moving a rotary fist towards the car, establish a wheel drive shaft in a nave of a forward wheel.
Connect the lower part of a rack with a rotary fist, insert two bolts and screw on them nuts, without tightening them it is final.
Install the lower lever on the spherical hinge and fix it by a bolt and nuts, without tightening them it is final.
Fix steering draft on a rotary fist.
Having combined earlier put tags, tighten nuts of fastening of the lower part of a rack to a rotary fist and a bolt and nuts of fastening of the spherical hinge to the lower lever.
Establish a brake disk and a support.
Screw a nut of fastening of a shaft of the drive of a wheel to a nave. On models since 2001 use a new nut. Previously tighten a nut.
Establish a wheel and fix it by nuts. Lower the car.
On the car standing on wheels finally tighten a nut of fastening of a shaft to a nave the moment of 216 N • m. On models till 2001 screw a lock-nut and the forelock record it from an otvorachivaniye. On models since 2001 hammer with the hammer and a punch a nut fillet into a groove of a power shaft.
Check and if necessary adjust the angles of installation of forward wheels.