Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
12. Suspension bracket
   General information
   Specifications
   Rack of a forward suspension bracket
   Dismantling and assembly of a depreciation rack
   Forward stabilizer of cross stability
   Lower lever of a forward suspension bracket
      Removal
      Installation
      Replacement of the spherical hinge of the lower lever of a forward suspension bracket
   Rotary fist and nave of a forward wheel
   Back stabilizer of cross stability
   Shock-absorber of a back suspension bracket
   Levers of a back suspension bracket
   Spring of a back suspension bracket
   Nave and bearing of a back wheel
13. Steering and running gear
14. Body
15. Electric equipment
Schemes of electric equipment


Toyota RAV4>> Suspension bracket>> Lower lever of a forward suspension bracket>> Replacement of the spherical hinge of the lower lever of a forward suspension bracket
Tighten the parking brake and block back wheels an emphasis.
Weaken nuts of fastening of a forward wheel. Lift a forward part of the car and establish it on support. Remove a forward wheel.
Take the forelock from a pin of the spherical hinge and weaken a nut of fastening of the spherical hinge to a rotary fist.

Fig. 12.14. Use of a stripper for separation of a pin of the spherical hinge from a rotary fist


Mount or stripper separate a pin of the spherical hinge from a rotary fist ( fig. 12.14 ). Turn off, as far as possible, a nut of fastening of a pin of the spherical hinge. A gap between a pin of the spherical hinge and the CV JOINT of a shaft of the drive of a wheel small also does not allow to turn off a nut at one time. Therefore act as follows: turn off a nut on 1–2 turns and wring out the spherical hinge down, again turn off a nut on 1–2 turns and wring out the spherical hinge down, and so to a full otvorachivaniye of a nut.

Fig. 12.11. An arrangement of a bolt and nuts of fastening of the spherical hinge to the lower lever of a forward suspension bracket


Turn out a bolt and two nuts of fastening of the spherical hinge to the lower lever of a forward suspension bracket (see fig. 12.11 ). Mount separate the spherical hinge from the lower lever of a forward suspension bracket and remove from the car.
Insert a pin of the spherical hinge into an opening of a rotary fist and screw a nut on a pin.
Install the lower lever on the spherical hinge and fix it by a bolt and nuts, having tightened them the moment specified in specifications.
Tighten a nut of fastening of a pin of the spherical hinge to a rotary fist and install the new forelock. If the opening in a pin for the forelock does not coincide with grooves on a nut, tighten a nut towards tightening until grooves on a nut coincide with an opening.
You make further installation in the sequence, the return to removal.