Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
12. Suspension bracket
   General information
   Specifications
   Rack of a forward suspension bracket
   Dismantling and assembly of a depreciation rack
   Forward stabilizer of cross stability
      Removal
      Installation
   Lower lever of a forward suspension bracket
   Rotary fist and nave of a forward wheel
   Back stabilizer of cross stability
   Shock-absorber of a back suspension bracket
   Levers of a back suspension bracket
   Spring of a back suspension bracket
   Nave and bearing of a back wheel
13. Steering and running gear
14. Body
15. Electric equipment
Schemes of electric equipment


Toyota RAV4>> Suspension bracket>> Forward stabilizer of cross stability>> Removal
Tighten the parking brake and block back wheels an emphasis.
Weaken nuts of fastening of a forward wheel. Lift a forward part of the car and establish it on support. Remove forward wheels.

Fig. 12.8. An arrangement of nuts of fastening of the stabilizer of cross stability on models till 2001


Fig. 12.9. An arrangement of nuts of fastening of the stabilizer of cross stability on models since 2001


Disconnect the stabilizer of cross stability from drafts of the stabilizer (fig. 12.8, 12.9) . At an otvorachivaniye of nuts of fastening of spherical hinges of draft of the stabilizer hold a six-sided key a pin of the spherical hinge from a provorachivaniye.
On release models till 2001 at removal of the stabilizer of cross stability turn off the top nut of fastening of draft of the stabilizer, and at removal of the lower lever of a forward suspension bracket — the lower nut.
Turn out bolts of fastening of the clips with plugs fixing the stabilizer of cross stability.
Remove the stabilizer of cross stability from the car.
Remove basic plugs from the stabilizer and check their state.

Fig. 12.10. Check of a condition of the spherical hinge of drafts of the stabilizer


Check a condition of spherical hinges of drafts of the stabilizer. For this purpose remove them from the car and fix in a vice ( fig. 12.10 ). Reject against the stop in one and other party a pin of the spherical hinge, then screw a nut on a pin. A dynamometer key turn a pin of the spherical hinge (one turn for 2–4 c), and on the fifth turn measure torque of a provorachivaniye which has to be not less than 0,04 N • m. Otherwise replace draft of the stabilizer.
Wire brush clear stabilizer zones on which basic plugs are installed.