Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
   General information
   Specifications
   Anti-blocking system of brakes (ABS)
   Replacement of front brake shoes
   Replacement of a support of a forward brake
   Check and replacement of brake disks
   Replacement of back brake shoes
   Replacement of the working brake cylinder
   Replacement of the main brake cylinder
   Replacement of sealing rings of a tank of the brake system
   Replacement of brake tubes and hoses
   Pumping of the hydraulic drive of brakes
   Check and replacement of the vacuum amplifier of brakes
   Adjustment of the parking brake
   Replacement of cables of the parking brake
   Adjustment of provision of a pedal of a brake
      Height of installation of a pedal
      Free wheeling of a pedal of a brake
      Brake pedal course stock
   Check and replacement of the switch of a stoplight
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
Schemes of electric equipment


Toyota RAV4>> Brake system>> Adjustment of provision of a pedal of a brake>> Height of installation of a pedal

Fig. 11.44. Height of installation of a pedal of a brake: 1 – pusher; 2 – stoplight switch; Х – height of installation of a pedal of a brake


Measure height of installation of a pedal of a brake which has to be in the limits given in specifications and in fig. 11.44 . If necessary adjust height of installation of a pedal of a brake as follows.
Remove the lower casing of a steering column.
Disconnect the electric socket from the stoplight switch.
Weaken a lock-nut of the switch of a stoplight and turn out it.
Weaken a pusher lock-nut.
Adjust height of installation of a pedal of a brake, rotating a pusher in one or other party.
Tighten a pusher lock-nut.
Install the switch of a stoplight and wrap it until a switch case contact with the brake pedal course limiter.
Turn out the stoplight switch on one turn.

Fig. 11.45. Measurement of a gap between a carving part of the case of the switch and the limiter of the course of a pedal of a brake: And = 0,5–2,4 mm


Measure distance between a carving part of the case of the switch and the limiter of the course of a pedal of a brake which has to be in limits of 0,5-2,4 mm ( fig. 11.45 ).
Tighten a stoplight switch lock-nut.
Connect the electric socket to the stoplight switch.
Check that stoplights light up when pressing a pedal of a brake and die away at its otpuskaniye.