Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
   General information
   Specifications
   Anti-blocking system of brakes (ABS)
   Replacement of front brake shoes
   Replacement of a support of a forward brake
      Removal
      Installation
   Check and replacement of brake disks
   Replacement of back brake shoes
   Replacement of the working brake cylinder
   Replacement of the main brake cylinder
   Replacement of sealing rings of a tank of the brake system
   Replacement of brake tubes and hoses
   Pumping of the hydraulic drive of brakes
   Check and replacement of the vacuum amplifier of brakes
   Adjustment of the parking brake
   Replacement of cables of the parking brake
   Adjustment of provision of a pedal of a brake
   Check and replacement of the switch of a stoplight
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
Schemes of electric equipment


Toyota RAV4>> Brake system>> Replacement of a support of a forward brake>> Removal
Tighten the parking brake and block back wheels an emphasis.
Weaken nuts of fastening of a forward wheel. Lift a forward part of the car and establish it on support. Remove a forward wheel.

Fig. 11.14. Reversing of the lower bolt of fastening of a support of a forward brake: And – the lower bolt; In – the top bolt; With – a hollow bolt of fastening of a brake hose


Fig. 11.19. Closing of an opening of a brake hose with a piece of a rubber hose


If the support is removed for access to other components, do not disconnect from it a brake hose. Otherwise turn out a hollow bolt of fastening of a brake hose to a support (C in fig. 11.14 ). For prevention of an effluence of brake fluid close an opening of a brake hose a stopper or a piece of a rubber hose of suitable diameter ( fig. 11.19 ).
Turn out the top and lower bolts of fastening of a support, at the same time the second key hold the directing fingers from a provorachivaniye (see fig. 11.14 ). If the support is removed for access to other components, a soft wire tie up it to a forward rack.