Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of the drive of driving wheels
   General information
   Specifications
   Shaft of the drive of forward wheels
   Shaft of the drive of back wheels on all-wheel drive cars
   Replacement of protective covers of hinges of a shaft of the drive of a wheel
   Driveshaft
   Basic bearing of the driveshaft
   Sealing cuffs of reverse main gear
      Replacement of a cuff of the leading flange
      Replacement of cuffs of shaft of the drive of wheels
   Differential on all-wheel drive cars
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
Schemes of electric equipment


Toyota RAV4>> Driveshaft and shaft of the drive of driving wheels>> Sealing cuffs of reverse main gear>> Replacement of cuffs of shaft of the drive of wheels
Removal
Emphasis block forward wheels to interfere with movement of the car. Lift a back part of the car and establish it on support. Lower the lever of the parking brake and install the gear shifting lever in neutral situation.
Apply with paint or a marker combination tags on a flange of differential and a flange of the internal CV JOINT of a shaft of the drive.

Fig. 10.4. An arrangement of nuts of fastening of the internal CV JOINT of a back shaft of the drive to a differential flange


Turn out 4 nuts and separate the internal CV JOINT of a shaft of the drive from a differential flange (see fig. 10.4 ).
Blow of the brass hammer to the mount established between an internal flange and a case of differential take a drive shaft from a differential case.
Edge of the flat screw-driver take a sealing cuff. At extraction do not scratch a groove for installation of a cuff.
Installation
Clear a groove for installation of a cuff. Grease an external surface and a working edge of a cuff with oil.
By tubular mandrel with outer diameter, a little smaller, than the outer diameter of a cuff, establish a sealing cuff in a groove. Check that the cuff is established without distortion and on the same depth, as earlier.
Establish a differential flange, at the same time be careful not to damage a working edge of a sealing cuff.
Check oil level in reverse main gear, if necessary add it.
Replacement of cuffs on differential
with two satellites
If on the car the differential with two satellites is established, remove differential from the car.
Turn out bolts and uncover a differential case.

Fig. 10.16. Removal of a lock ring of fastening of a semi-axial gear wheel of differential


Passatizhami remove a lock ring of fastening of a semi-axial gear wheel of differential and remove a shaft with a flange ( fig. 10.16 ).
Edge of the flat screw-driver take a sealing cuff. At extraction do not scratch a groove for installation of a cuff.
Clear a groove for installation of a cuff. Grease an external surface and a working edge of a cuff with oil.
By tubular mandrel with outer diameter, a little smaller, than the outer diameter of a cuff, establish a sealing cuff in a groove. Check that the cuff is established without distortion and on the same depth, as earlier.
Establish in a differential case a shaft with a flange.
Establish to Passatizhami a lock ring of fastening of a semi-axial gear wheel of differential.
Clear privalochny surfaces of a cover and a case of differential of the sealant remains. Apply a thin film of RTV sealant on a privalochny surface of a case of differential, establish a cover and fix it by bolts.
You make further installation in the sequence, the return to removal.