Fig. 10.15. The provision of installation of the basic bearing on a forward part of the driveshaft
Install the basic bearing and a washer on a forward part of the driveshaft (
Install a flange on the driveshaft, having combined the tags put before removal, and fix it by a new nut with a washer. Clamp the driveshaft in a vice with soft sponges and tighten a nut of fastening of the basic bearing. The hammer and a chisel you zakontrit a nut.
Connect forward and back parts of the driveshaft, having combined the tags put before removal, and fix by bolts, having tightened them at this stage by hand.
Grease working edges of a sealing cuff of the transmission. Insert a forward part of the driveshaft into the transmission and screw, but do not tighten, bolts of fastening of an arm of the basic bearing of the driveshaft to the car bottom.
Connect the back universal hinge of the driveshaft to a flange of the main reverse gear, having combined the tags put before removal and tighten nuts and bolts the moment of 74 N • m.
When the assistant presses a brake pedal, tighten bolts of fastening of two parts of the driveshaft.
Adjust position of the basic bearing of the driveshaft.