Wrap up vents of the internal end of a shaft of the drive an adhesive tape not to damage a protective cover about sharp sides of shliyets of a shaft.
Pull a collar and a protective cover over a drive shaft.
Establish трипоид on vents of a shaft of the drive and fix it by a lock ring. Grease трипоид and the internal surface of the case of the hinge. Insert the hinge into the case and fill it with the lubricant remains.
Put on a protective cover the hinge, at the same time check that seats of a cover were established in the grooves intended for them.
Fig. 10.8. Place of measurement of length of a shaft of the drive
Measure the drive shaft length which has to correspond to length specified in specifications
Fix a protective cover by collars, the screw-driver previously having raised an inner edge of a cover for alignment of pressure of air under a cover.
Fig. 10.9. Use of the special tool for fastening of a collar: 1 – protective cover; 2 – special tool; 3 – collar clip
The special tool
is necessary for fixing of collars
. Establish sponges of the tool on corners of a clip of a collar and in this situation tighten sponges the screw.
Install a drive shaft on the car.