Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of the drive of driving wheels
   General information
   Specifications
   Shaft of the drive of forward wheels
      Removal
      Installation
   Shaft of the drive of back wheels on all-wheel drive cars
   Replacement of protective covers of hinges of a shaft of the drive of a wheel
   Driveshaft
   Basic bearing of the driveshaft
   Sealing cuffs of reverse main gear
   Differential on all-wheel drive cars
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
Schemes of electric equipment


Toyota RAV4>> Driveshaft and shaft of the drive of driving wheels>> Shaft of the drive of forward wheels>> Removal
Remove a cap from a nave or a decorative cap of a wheel. On models till 2001 take the forelock and turn off a lock-nut of fastening of a shaft of the drive to a nave of a forward wheel. On models since 2001 unbend the nut fillet bent in a wheel drive shaft groove.
Face key with a big shoulder (with the extender) turn off a nut of fastening of a shaft of the drive to a nave of a forward wheel.
Weaken nuts of fastening of a forward wheel, then lift a forward part of the car and establish it on support. Remove a wheel.
Merge oil from the transmission.
Turn out nuts and a bolt and disconnect steering draft and the lower lever of a forward suspension bracket from a rotary fist.
Reject from the car a rotary fist aside and take a drive shaft from a nave of a forward wheel. If the shaft of the drive does not manage to be taken from a nave manually, beat out it a kiyanka. A soft wire suspend the external end of a shaft to a body, do not allow it to hang freely as at the same time the internal CV JOINT of a shaft of the drive can be damaged.

Fig. 10.1. An arrangement of bolts of fastening of the basic bearing of the right shaft of the drive on front-wheel cars with the automatic transmission


If the right shaft of the drive on the front-wheel car with the automatic transmission is removed, turn out bolts of fastening of an arm of the basic bearing (fig. 10.1) .
If the right shaft of the drive on the front-wheel car with the mechanical transmission is removed, remove a lock ring of fastening of the basic bearing.

Fig. 10.2. Use of mount for extraction of a shaft of the drive from the transmission


Blow of the brass hammer to the mount established between the internal CV JOINT and a case of the transmission take a drive shaft from the transmission and remove it from the car (fig. 10.2) . On models with the basic bearing for extraction of a shaft of the drive from the transmission insert mount between a case of the transmission and a support of the bearing.