Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
   General information
   Specifications
   Repair of the transmission
   The repair and adjusting work performed on cars with the mechanical transmission
   The repair and adjusting work performed on cars with the automatic transmission
      Diagnostics of the automatic transmission
      Replacement of sealing cuffs
      Check, adjustment and replacement of a cable of management of a butterfly valve
      Replacement and adjustment of a cable of the selector
      Replacement and adjustment of the switch of blocking of a starter (PNP)
      Check of system of blocking of the lever of the selector and lock of ignition
      Removal and installation of the automatic transmission on models with one leading bridge
      Removal and installation of the automatic transmission on all-wheel drive models
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
Schemes of electric equipment


Toyota RAV4>> Transmission>> The repair and adjusting work performed on cars with the automatic transmission>> Replacement and adjustment of the switch of blocking of a starter (PNP)
Adjustment
If start of the engine is possible in any other situation, except "P" and "N", adjust the switch of blocking of a starter.
Tighten the parking brake and block back wheels. Lift a forward part of the car and establish it on support. Remove a mudguard of a motor compartment.
Install the selector lever in interior of the car in situation "N".
Weaken bolts of fastening of the switch of blocking of a starter.
Install the lever of the choice of transfers on the transmission to situation "N".

Fig. 9.23. Combination of the line (1) on the switch of blocking of a starter with a flute (2) on a shaft of the lever of the choice of transfers on models with one leading bridge of release of 1996 and 1997 and all-wheel drive models from 1996 to 2001


Fig. 9.24. Combination of the line (2) on the switch of blocking of a starter with a flute (3) on a shaft of the lever of the choice of transfers and an arrangement of bolts (1) of fastening of the switch on release models since 2001


Combine the line on the switch of blocking of a starter with a flute on a shaft of the lever of the choice of transfers (fig. 9.23, 9.24) .
Tighten bolts of fastening of the switch of blocking of a starter and check its work. If launch of the engine is still possible in any other situation, except "P" and "N", replace the switch.
Replacement
Switch off ignition and disconnect a wire of "weight" from the rechargeable battery.
Tighten the parking brake and block back wheels. Lift a forward part of the car and establish it on support. Remove a mudguard of a motor compartment.
Install the selector lever in interior of the car in situation "N".
Turn off nuts and remove the lever of the choice of transfers from a transmission shaft.
Disconnect the electric socket from the switch.
Turn out bolts and remove the switch from a shaft of the choice of transfers of the transmission.
Combine the line on the switch with a flute on a shaft of the choice of transfers and install the switch on a shaft.
Turn the switch before combination of the line on the switch of blocking of a starter with a flute on a shaft of the lever of the choice of transfers (see fig. 9.23, 9.24 ). Tighten bolts of fastening of the switch and connect to it the electric socket.
Install the lever of the choice of transfers on a shaft and connect a wire of "weight" to the rechargeable battery. Check operation of the switch. Launch of the engine has to be is possible only in the family way of the P and N selector.