Device and repair of Toyota RAV4 SUVs (Toyota RAV) - Replacement and adjustment of a cable of the selector-//

Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
   General information
   Specifications
   Repair of the transmission
   The repair and adjusting work performed on cars with the mechanical transmission
   The repair and adjusting work performed on cars with the automatic transmission
      Diagnostics of the automatic transmission
      Replacement of sealing cuffs
      Check, adjustment and replacement of a cable of management of a butterfly valve
      Replacement and adjustment of a cable of the selector
      Replacement and adjustment of the switch of blocking of a starter (PNP)
      Check of system of blocking of the lever of the selector and lock of ignition
      Removal and installation of the automatic transmission on models with one leading bridge
      Removal and installation of the automatic transmission on all-wheel drive models
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
Schemes of electric equipment


Toyota RAV4>> Transmission>> The repair and adjusting work performed on cars with the automatic transmission>> Replacement and adjustment of a cable of the selector
       PREVENTIONS
Cars are equipped with security systems (SRS) including safety cushions and natyazhitel of seat belts. Before work about sensors of blow, the dashboard and a steering column disconnect at first negative, and then positive plugs from the rechargeable battery and wait about two minutes. It will exclude unauthorized disclosure of safety cushions and operation of natyazhitel of seat belts which can cause a trauma.

Replacement
Being under the car, remove the lower mudguard of a motor compartment.
Lift a forward part of the car and establish it on support.
Turn off a nut of fastening of a cable of the selector and disconnect it from the lever of the choice of transfers on the forward party of the transmission.
Remove a clip and remove a cable cover from an arm on the transmission.
Remove the central console.
Disconnect a cable from the lower part of the lever of the selector, then squeeze clamps and separate a cable cover from a selector lever casing.
Take a cable from a sealing ring in a partition of a motor compartment.
You make installation in the sequence, the return to removal.
After installation adjust a selector cable.
Adjustment
Weaken a nut of fastening of a cable of the selector to the lever of the choice of transfers on the forward party of the transmission.

Fig. 9.20. Provisions P, R and N of the lever of the choice of transfers on the transmission on models with one leading bridge of release of 1996 and 1997 and all-wheel drive models of release from 1996 to 2001


Fig. 9.21. Provisions P, R and N of the lever of the choice of transfers on the transmission on models with one leading bridge of release from 1998 to 2001


Fig. 9.22. Provisions P, R and N of the lever of the choice of transfers on the transmission on release models since 2001


Install the lever of the choice of transfers on the transmission to situation "N" (fig. 9.20, 9.21, 9.22) .
Install the selector lever in interior of the car in situation "N".
The assistant has to keep the selector lever in interior of the car with small pressure towards situation "R", at this time tighten a nut of fastening of a cable of the selector to the lever of the choice of transfers on the transmission.
Moving the selector lever, be convinced that the lever of the choice of transfers also moves to the relevant provisions. In each position of the lever of the selector try to start the engine. The starter has to join only at provisions of the lever of the P and N selector.