Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
   General information
   Specifications
   Repair of the transmission
   The repair and adjusting work performed on cars with the mechanical transmission
      Replacement of cables of control of the transmission
      Removal and installation of the lever of gear shifting
      Check and replacement of the switch of lamps of a backing
      Replacement of the oil heater of the transmission
      Removal and installation of the mechanical transmission on cars with one leading bridge
      Removal and installation of the mechanical transmission on fully - driving cars
   The repair and adjusting work performed on cars with the automatic transmission
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
Schemes of electric equipment


Toyota RAV4>> Transmission>> The repair and adjusting work performed on cars with the mechanical transmission>> Check and replacement of the switch of lamps of a backing
Check

Fig. 9.2. An arrangement of the switch of lamps of a backing above a transmission case


The switch of lamps of a backing is located above a case of the transmission (fig. 9.2) .
Include ignition and include transfer of a backing, at the same time the switch has to include backing lamps.
If lamps of a backing did not light up, check serviceability of a safety lock in an electric chain of lamps of a backing.
If the safety lock is serviceable, then disconnect the electric socket from the switch and an ohmmeter check a condition of its contacts which by the included transfer of a backing have to be closed (resistance is equal to 0). Install the gear shifting lever in neutral situation, at the same time contacts of the switch have to be opened and the ohmmeter has to show infinitely big resistance (lack of conductivity). In case of malfunction replace the switch.
If the switch is serviceable, check a condition of an electric chain between a safety lock and the switch. If the electric chain is serviceable, possibly, lamps in backing lamps fused.
If lamps in lamps of a backing are serviceable, check the wire connecting the switch to lamps.
Replacement
Disconnect the electric socket from the switch of lamps of a backing.
Turn out the switch from a transmission case.
Before installation check the new switch. Connect an ohmmeter to contacts of the switch and be convinced that at the pressed switch plunger contacts are closed, and at released — are opened.
Screw the switch in a case of the transmission and tighten it the required moment.
Connect the electric socket to the switch.
Check work of lamps of a backing.