Device and repair of Toyota RAV4 SUVs (Toyota RAV) - Replacement of cables of control of the transmission-//

Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
   General information
   Specifications
   Repair of the transmission
   The repair and adjusting work performed on cars with the mechanical transmission
      Replacement of cables of control of the transmission
      Removal and installation of the lever of gear shifting
      Check and replacement of the switch of lamps of a backing
      Replacement of the oil heater of the transmission
      Removal and installation of the mechanical transmission on cars with one leading bridge
      Removal and installation of the mechanical transmission on fully - driving cars
   The repair and adjusting work performed on cars with the automatic transmission
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
Schemes of electric equipment


Toyota RAV4>> Transmission>> The repair and adjusting work performed on cars with the mechanical transmission>> Replacement of cables of control of the transmission
Cables of control of the transmission are not regulated therefore in case of damage or stretching replace them.
Removal

Fig. 9.1. Cables of control of the transmission on models till 2001: 1 – gear shifting lever handle; 2 – corrugated protective cover; 3 – central console; 4 – clip; 5 – clip; 6 – arm; 7 – gear shifting lever block; 8 – clip; 9 – washer; 10 – cable of the choice of transfers; 11 – washer; 12 – washer; 13 – clip; 14 – clip; 15 – gear shifting cable; 16 – holder; 17 – consolidation; 18 – holder of consolidation; 19 – panel of a side upholstery; 20 – panel of a side upholstery


In a motor compartment remove clips and washers and disconnect cables from levers of the transmission (fig. 9.1) .
Turn out screws, remove the holder of consolidation and consolidation of cables from a partition of a motor compartment.
In interior of the car remove the central console.
Remove clips of fastening of covers of cables to the gear shifting lever basis.
Remove clips and washers and disconnect cables from the gear shifting lever block.
From interior of the car turn out screws and remove the holder of consolidation of cables. Extend cables in interior of the car.
Installation
You make installation in the sequence, the return to removal.