Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
   General information
   Precautionary measures at operation and repair of system of ignition
   Technical characteristics of system of ignition
   Check of system of ignition and its elements
      Check and replacement of coils of ignition
      Replacement of the switchboard on models from 1996 to 1998
      Replacement of the distributor of ignition on models from 1996 to 1998
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
Schemes of electric equipment


Toyota RAV4>> System of ignition>> Check of system of ignition and its elements>> Replacement of the distributor of ignition on models from 1996 to 1998
You make removal of the distributor of ignition on models from 1996 to 1998 as follows:
Switch off ignition and disconnect a wire of "weight" from the rechargeable battery.
Disconnect electric sockets from the ignition distributor.
Make sure that about the plug of connection of a high-voltage wire of a candle of the first cylinder on a cover of the distributor of ignition there is a tag "1", otherwise put a tag.
Uncover the distributor of ignition and turn a bent shaft of the engine in situation at which the rotor will be directed to the 1 plug of a high-voltage wire of a candle of the first cylinder, at the same time the piston of the first cylinder will be in VMT in a compression step.

Fig. 6.5. A combination tag arrangement on the distributor of ignition and a cover of a head of the block of cylinders


Apply a tag on the case of the distributor of ignition and a cover of a head of the block of cylinders, for repeated installation of the distributor of ignition in a starting position (fig. 6.5) .
Turn out a bolt and remove the ignition distributor.

       PREVENTION
Do not turn a bent shaft of the engine at the removed ignition distributor as the provision of adjusting tags will be violated.

You make installation of the distributor of ignition on models from 1996 to 1998 as follows:
If the bent shaft was turned at the removed ignition distributor, install the piston of the first cylinder in VMT in a compression step.

Fig. 6.6. At installation of the distributor of ignition the ledge on a shaft of the distributor of ignition has to enter a groove in a camshaft end face


Install the ignition distributor with a new sealing ring, having combined previously put tags. At installation the ledge on a shaft of the distributor of ignition has to enter a groove in an end face of the camshaft (fig. 6.6) .
Fix by a bolt the ignition distributor.
Further installation is carried out to the sequences, the return to removal.