Device and repair of Toyota RAV4 SUVs (Toyota RAV) - An accelerator cable-//

Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
   General information
   Technical characteristics of system of injection of fuel
   Dropping pressure in fuel system
   General check of fuel system
   Fuel pump
   Fuel pressure regulator
   Fuel level sensor
   Fuel tank
   Case of the air filter
   Accelerator cable
   Electronic system of injection of fuel
   Damper of pulsations of fuel on models since 2001
   Distributive fuel highway and nozzles
   System of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
Schemes of electric equipment


Toyota RAV4>> Fuel system and system of production of the fulfilled gases>> Accelerator cable
You make removal of a cable of an accelerator as follows:
Switch off ignition and disconnect a wire of "weight" from the rechargeable battery.

Fig. 5.22. Weakening of a lock-nut of fastening of a cover of a cable to throttle knot


Weaken a lock-nut of fastening of a cover of a cable to throttle knot (fig. 5.22) .
Turn the lever of throttle knot and a needle or passatizha remove an accelerator cable from a groove in the lever.
Disconnect an accelerator cable from an accelerator pedal.
Take an accelerator cable from a partition in a motor compartment.
You carry out installation of a cable of an accelerator to the sequences, the return to removal. Make sure that before installation of a cable of an accelerator in a partition of a motor compartment the condensing ring is established.
For adjustment of a cable of an accelerator execute the following:
– turn off an adjusting nut on 3 mm from a cable arm;
– eliminate any sagging of a cable;
– tighten a lock-nut and check a cable deflection accelerators between the lever of throttle knot and a cover of a cable which has to make 9–12 mm. If the deflection goes beyond the specified limits, weaken a lock-nut and, rotating an adjusting nut, establish the required deflection;
– after adjustment of a cable of an accelerator, the assistant has to press and release an accelerator pedal, at the same time the lever of throttle knot has to turn from an emphasis against the stop. Check that the cable of an accelerator moves smoothly, without jammings.