Device and repair of Toyota RAV4 SUVs (Toyota RAV) - The fuel pressure regulator-//

Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
   General information
   Technical characteristics of system of injection of fuel
   Dropping pressure in fuel system
   General check of fuel system
   Fuel pump
   Fuel pressure regulator
   Fuel level sensor
   Fuel tank
   Case of the air filter
   Accelerator cable
   Electronic system of injection of fuel
   Damper of pulsations of fuel on models since 2001
   Distributive fuel highway and nozzles
   System of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
Schemes of electric equipment


Toyota RAV4>> Fuel system and system of production of the fulfilled gases>> Fuel pressure regulator
You make removal of the regulator of pressure of fuel as follows.
Dump pressure in fuel system.
Switch off ignition and disconnect a wire of "weight" from the rechargeable battery.
Remove the block of the fuel pump / fuel level sensor from the fuel tank.
Till 2001 you make further removal of the regulator for models of cars in the following order:
– remove a clip, the fixing pressure regulator to the fuel filter, then weaken a collar and remove a hose from pressure regulator;

Fig. 5.13. An arrangement of bolts of fastening of the regulator of pressure of fuel to the block of the fuel pump / fuel level sensor on models till 2001


– turn out screws and take off the regulator pressure of the block of the fuel pump / fuel level sensor (fig. 5.13) ;
Since 2001 you make further removal of the regulator for models of cars in the following order:
– remove an absorption plate from the block of the fuel pump / fuel level sensor.
– release from clamps and pick up the fuel phone from the fuel pressure regulator.

Fig. 5.14. A fuel pressure regulator arrangement in the block of the fuel pump / fuel level sensor on models since 2001


– take the fuel pressure regulator from the block of the fuel pump / fuel level sensor (fig. 5.14) .
You carry out installation of the regulator of pressure of fuel to the sequences, the return to removal, taking into account the following: before installation of the regulator of pressure of fuel surely establish on it a new sealing ring.