Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
4. Cooling systems and conditioning
   General information
   Specifications
   Service and repair of the cooling system
      Thermostat
      Radiator fan
      Radiator and broad tank
      Water pump
      Sensor of the index of temperature of cooling liquid
      Radiator fan thermoswitch
      Heater fan electric motor
      Knot of management of systems of heating and air conditioning
      Heater radiator
   Check and service of the air conditioning system
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
Schemes of electric equipment


Toyota RAV4>> Cooling systems and conditioning>> Service and repair of the cooling system>> Knot of management of systems of heating and air conditioning
Replacement of knot of management
Prevention

       PREVENTION
Cars are equipped with security systems (SRS) including safety cushions and natyazhitel of seat belts. Before work about sensors of blow, the dashboard and a steering column disconnect at first negative, and then positive plugs from the rechargeable battery and wait 2 min. It will exclude unauthorized disclosure of safety cushions and operation of natyazhitel of seat belts which can cause injuries.

Switch off ignition and disconnect a wire of "weight" from the rechargeable battery.
Remove the central overlay of the dashboard.
On release cars till 2001 remove a ware box and the lower central overlay of the dashboard. Remove handles of management and the control panel of heating and conditioning.
On release cars since 2001 remove the radio receiver and the lower left panel from the central console.
Disconnect cables of management from levers and a cover of cables from clips on knot of management of heating and the air conditioning system.

Fig. 4.22. An arrangement of screws of fastening of knot of management of heating and conditioning on cars till 2001


Fig. 4.23. An arrangement of screws and clamps (in the bottom of) fastening of knot of management of heating and conditioning on cars since 2001


Turn out the screws located on the forward party of knot of management (fig. 4.22, 4.23) .
Take from the dashboard knot of management of heating and the air conditioning system together with the wires and cables connected to it.
You make installation in the sequence, the return to removal.
Start the engine and check functioning of systems of heating and air conditioning.
Adjustment of cables
managements on cars
release till 2001
To adjust a cable of control of the air supply gate in interior of the car, establish a control lever in situation RECIRC, connect a cable and fix a cable cover by a clip.
To adjust a cable of the management of air temperature given to interior of the car, establish a control lever in position of COOL, connect a cable and fix a cable cover by a clip.
To adjust a cable of management of distribution of streams of air, establish a control lever in position of DEF, connect a cable and fix a cable cover by a clip.
Adjustment of cables
managements on cars
release since 2001
To adjust a cable of the management of air temperature given to interior of the car, establish a control lever in position of MAX COOL, connect a cable and fix a cable cover by a clip.
To adjust a cable of management of distribution of streams of air, move a control lever against the stop in the direction to a back part of the car. Connect a cable to the lever and fix a cable cover by a clip.