Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
   Repair of the engine 3S-FE without its removal from the car
   Repair of the engine 1AZ-FE without its removal from the car
   Diagnostics and preparation of the engine for capital repairs
      Specifications for check
      General information
      Check of pressure of oil
      Check of a compression in engine cylinders
      Diagnostics of the engine by means of the vacuum gage
      Alternative to capital repairs of the engine
      General recommendations about removal and installation of the engine
      Removal and installation of the engine
      Sequence of dismantling of the engine
      Start and running in of the engine after capital repairs
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
Schemes of electric equipment


Toyota RAV4>> Engines>> Diagnostics and preparation of the engine for capital repairs>> Start and running in of the engine after capital repairs
Fill in engine oil and cooling liquid.
Turn out from the engine of a spark plug and disconnect the electric socket of giving of tension to the fuel pump.
Starter turn a bent shaft of the engine until the control lamp of pressure of oil goes out.
Screw spark plugs and connect the electric socket of giving of tension to the fuel pump.
Launch the engine. Perhaps, launch of the engine will be more long as time for creation of pressure in fuel system will be required.
Warm up the engine up to the working temperature. In process of warming up of the engine you watch closely possible emergence of leak of oil, fuel or cooling liquid. Emergence of unusual smells and smoke from the details which are affected by high temperature because of burning out of the remains of oil is allowed.
Stop the engine and check levels of engine oil and cooling liquid and if necessary add.
If new pistons, piston rings, radical and connecting rods were installed, then the engine has to pass a running in throughout the first 800 km of a run. In the period of a running in operation with completely open butterfly valve or with too small speed on any transfer is not allowed.
After a running in replace engine oil and an oil filter.
After the run of 3000 km replace engine oil and an oil filter again.