Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
   Repair of the engine 3S-FE without its removal from the car
   Repair of the engine 1AZ-FE without its removal from the car
      General information
      Specifications
      Installation of the piston of the first cylinder in the top dead point (TDP)
      Cover of a head of the block of cylinders
      System of change of phases of gas distribution (VVT — Variable Valve Timing)
      Chain of the drive of the gas-distributing mechanism and asterisk
      Camshafts and pushers of valves
      Inlet collector
      Final collector
      Head of the block of cylinders
      Pulley/quencher of fluctuations
      Forward sealing ring of a bent shaft
      Oil pallet
      Oil pump
      Drive flywheel / plate
      Back sealing ring of a bent shaft
      Support of the power unit
   Diagnostics and preparation of the engine for capital repairs
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
Schemes of electric equipment


Toyota RAV4>> Engines>> Repair of the engine 1AZ-FE without its removal from the car>> Forward sealing ring of a bent shaft
You make replacement in the following order:
– remove a pulley / quencher of fluctuations from a bent shaft;
– note situation and depth of installation of an old sealing ring;

Fig. 3.87. Extraction of a forward sealing ring of a bent shaft from a chain cover


– the special tool or the big screw-driver get a sealing ring from a cover of a chain (fig. 3.87) . Be careful not to damage a cover of a chain and a bent shaft;
– clear a nest of a sealing ring. Oil engine an external surface of a sealing ring;
– a tubular mandrel, with outer diameter a little smaller the outer diameter of a ring, establish a sealing ring into place. Check that the ring is established without distortion and on the same depth, as earlier established ring;

Fig. 3.88. Installation of the plug on a nave of a pulley / quencher of fluctuations


– check a condition of a surface on the nave of a pulley / quencher of fluctuations contacting to a sealing ring. If on a surface of a nave there are flutes from long contact with a sealing ring, for restoration of a surface install the plug delivered in spare parts (fig. 3.88) on a nave . The plug can be installed, napressovyvy by the hammer through wooden whetstone;
– grease a nave or the plug on a nave with fresh engine oil and establish a pulley / quencher of fluctuations on a bent shaft;
– install the special adaptation fixing it from a provorachivaniye on a pulley/quencher of fluctuations, and a face key with a big shoulder screw the central bolt and tighten its moment 170 N • m.
You carry out further installation to the sequences, the return to removal.