Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
   Repair of the engine 3S-FE without its removal from the car
   Repair of the engine 1AZ-FE without its removal from the car
      General information
      Specifications
      Installation of the piston of the first cylinder in the top dead point (TDP)
      Cover of a head of the block of cylinders
      System of change of phases of gas distribution (VVT — Variable Valve Timing)
      Chain of the drive of the gas-distributing mechanism and asterisk
      Camshafts and pushers of valves
      Inlet collector
      Final collector
      Head of the block of cylinders
      Pulley/quencher of fluctuations
      Forward sealing ring of a bent shaft
      Oil pallet
      Oil pump
      Drive flywheel / plate
      Back sealing ring of a bent shaft
      Support of the power unit
   Diagnostics and preparation of the engine for capital repairs
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
Schemes of electric equipment


Toyota RAV4>> Engines>> Repair of the engine 1AZ-FE without its removal from the car>> Pulley/quencher of fluctuations
Removal
You make removal in the following order:
– switch off ignition and disconnect a wire of "weight" from the rechargeable battery;
– take off a belt of the drive of hinged units;
– tighten the parking brake and block back wheels an emphasis;
– weaken nuts of fastening of the right forward wheel. Lift a forward part of the car and establish on support. Remove the right forward wheel and an antisplash guard of an arch of the right forward wheel;

Fig. 3.85. Use of special device for fixing of a pulley / quencher of fluctuations from a provorachivaniye and an otvorachivaniye of the central bolt


– install the special adaptation fixing it from a provorachivaniye on a pulley / quencher of fluctuations, and a face key with a big shoulder turn out the central bolt (fig. 3.85) ;
– screw the central bolt on several rounds of a carving and a stripper remove a pulley/quencher of fluctuations from a bent shaft. Turn out the central bolt and remove a pulley / quencher of fluctuations from the car.

       PREVENTION
Do not use a stripper which captures are established on an external surface of a pulley / quencher of fluctuations as it will lead to its damage.

Installation
You make installation in the following order:

Fig. 3.86. An arrangement of a spline of a bent shaft for fixing of a pulley / quencher of fluctuations


– manually establish as far as possible a pulley / quencher of fluctuations on a bent shaft of the engine, at the same time combine a shponochny groove on a pulley with a spline of a bent shaft (fig. 3.86) ;
– install the special adaptation fixing it from a provorachivaniye on a pulley / quencher of fluctuations, and a face key with a big shoulder screw the central bolt and tighten its moment 170 N • m.
You carry out further installation to the sequences, the return to removal.