Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
   Repair of the engine 3S-FE without its removal from the car
   Repair of the engine 1AZ-FE without its removal from the car
      General information
      Specifications
      Installation of the piston of the first cylinder in the top dead point (TDP)
      Cover of a head of the block of cylinders
      System of change of phases of gas distribution (VVT — Variable Valve Timing)
      Chain of the drive of the gas-distributing mechanism and asterisk
      Camshafts and pushers of valves
      Inlet collector
      Final collector
      Head of the block of cylinders
      Pulley/quencher of fluctuations
      Forward sealing ring of a bent shaft
      Oil pallet
      Oil pump
      Drive flywheel / plate
      Back sealing ring of a bent shaft
      Support of the power unit
   Diagnostics and preparation of the engine for capital repairs
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
Schemes of electric equipment


Toyota RAV4>> Engines>> Repair of the engine 1AZ-FE without its removal from the car>> General information
This section is devoted to repair of the engine 1AZ-FE installed in a motor compartment.
The engine 1AZ-FE of 2,0 l was installed on the RAV4 cars since 2001. This engine represents a new design, with aluminum the block of cylinders and the oil pallet. In a head of the block of cylinders about 2 camshafts (DOHC) with four valves are installed on the cylinder. The drive of camshafts is carried out by a chain from a bent shaft.
Before work on the engine clear a motor compartment and the engine the degreasing means. It considerably will facilitate performance of any works.
For improvement of access to the engine it is desirable to remove a cowl. Capes protect wings to prevent damage of a paint and varnish covering.
On the engine installed in the car it is possible to adjust, remove, check, replace and to establish the following details, knots and units:
– inlet and final collectors;
– laying of inlet and final collectors;
– oil pallet;
– laying of the oil pallet;
– sealing rings of a bent shaft;
– head of the block of cylinders;
– laying of a head of the block of cylinders;
– oil pump;
– starter;
– generator;
– camshafts;
– poliklinovy belts of the drive of hinged units;
– chain of the drive of the gas-distributing mechanism;
– pulleys;
– support of the power unit;
– drive flywheel/plate.