Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
   Repair of the engine 3S-FE without its removal from the car
      General information
      Specifications
      Installation of the piston of the first cylinder in the top dead point (TDP)
      Cover of a head of the block of cylinders
      Inlet collector
      Final collector
      Gear belt and pulleys of a gear belt
      Forward sealing ring of a bent shaft
      Sealing ring of the camshaft
      Camshafts and pushers of valves
      Head of the block of cylinders
      Oil pallet
      Oil pump
      Drive flywheel / plate
      Back sealing ring of a bent shaft
      Support of the power unit
   Repair of the engine 1AZ-FE without its removal from the car
   Diagnostics and preparation of the engine for capital repairs
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
Schemes of electric equipment


Toyota RAV4>> Engines>> Repair of the engine 3S-FE without its removal from the car>> Drive flywheel / plate
Removal
You make removal in the following order:
– remove the transmission. Check and if necessary replace a forward sealing ring of the transmission;
– note a marker or paint the provision of coupling assembled in relation to a flywheel;
– using the special tool or the screw-driver, for teeths of a gear wreath of a flywheel block it from a provorachivaniye;
– gradually on diagonal weaken coupling fastening bolts assembled, turning each bolt half way until it is terminated a spring, and bolts can be unscrewed manually;
– remove press and conducted clutch plates. Check a condition of coupling;
– note a marker or paint the provision of a flywheel in relation to a bent shaft;
– using the special tool or the screw-driver, for teeths of a gear wreath of a flywheel block it from a provorachivaniye;

Fig. 3.45. Removal of a back adjusting plate on cars with the automatic transmission


– turn out bolts and, being careful, remove a drive flywheel / plate from a bent shaft. On cars with the automatic transmission, from two parties of a plate of the drive there are adjusting plates which need to be held together with a plate of the drive (fig. 3.45) .
Installation
On models with the mechanical transmission check a flywheel for wear from coupling and a condition of teeths of a gear wreath of a flywheel.
If there is a wear of the surface of a flywheel contacting to a clutch plate, the flywheel needs to be pereshlifovat.
Check a condition of a back sealing ring of a bent shaft. If there is oil leak, replace a sealing ring.
Place a drive flywheel / plate opposite to a bent shaft and combine the tags put before removal. On some engines for orientation and fixing of a flywheel there is a spline or openings for fastening of a flywheel are located at different distances one from another. Apply the kontrovochny structure interfering their self-unscrewing (the blocking liquid) on a carving of bolts of fastening of a flywheel / plate of the drive.
Using the special tool or the screw-driver, for teeths of a gear wreath of a flywheel block it from a provorachivaniye and gradually, cross-wise tighten fastening bolts the moment of 83-88 N • m.
Further installation is carried out to the sequences, the return to removal.