Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
   Repair of the engine 3S-FE without its removal from the car
      General information
      Specifications
      Installation of the piston of the first cylinder in the top dead point (TDP)
      Cover of a head of the block of cylinders
      Inlet collector
      Final collector
      Gear belt and pulleys of a gear belt
      Forward sealing ring of a bent shaft
      Sealing ring of the camshaft
      Camshafts and pushers of valves
      Head of the block of cylinders
      Oil pallet
      Oil pump
      Drive flywheel / plate
      Back sealing ring of a bent shaft
      Support of the power unit
   Repair of the engine 1AZ-FE without its removal from the car
   Diagnostics and preparation of the engine for capital repairs
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
Schemes of electric equipment


Toyota RAV4>> Engines>> Repair of the engine 3S-FE without its removal from the car>> Forward sealing ring of a bent shaft
You make replacement in the following order:
– take off a gear belt and a pulley of a gear belt from a bent shaft;

Fig. 3.22. Use of the screw-driver for removal of a forward sealing ring of a bent shaft


– an edge of the screw-driver take a sealing ring from a nest (fig. 3.22) . For simplification of removal of a sealing ring, a sharp knife cut off a working edge from the reinforced basis on all perimeter of a sealing ring (fig. 3.23) . At removal do not scratch a nest of a sealing ring and a bent shaft;

Fig. 3.23. The place of cutting of a working edge from the reinforced basis of a sealing ring


– clear a nest of a sealing ring and a neck of a bent shaft. Oil engine an external surface and a working edge of a sealing ring;
– a tubular mandrel, with outer diameter a little smaller the outer diameter of a ring, establish a sealing ring into place. Check that the ring is established without distortion and on the same depth, as earlier established ring;
– establish a pulley on a bent shaft and a gear belt;
– launch the engine and check tightness of a forward sealing ring of a bent shaft.