Toyota PAB4-Toyota RAV4
1. Operation of the car
2. Maintenance
3. Engines
   Repair of the engine 3S-FE without its removal from the car
      General information
      Specifications
      Installation of the piston of the first cylinder in the top dead point (TDP)
      Cover of a head of the block of cylinders
      Inlet collector
      Final collector
      Gear belt and pulleys of a gear belt
      Forward sealing ring of a bent shaft
      Sealing ring of the camshaft
      Camshafts and pushers of valves
      Head of the block of cylinders
      Oil pallet
      Oil pump
      Drive flywheel / plate
      Back sealing ring of a bent shaft
      Support of the power unit
   Repair of the engine 1AZ-FE without its removal from the car
   Diagnostics and preparation of the engine for capital repairs
4. Cooling systems and conditioning
5. Fuel system and system of production of the fulfilled gases
6. System of ignition
7. The control system and decrease in toxicity of the fulfilled gases
8. Coupling
9. Transmission
10. Driveshaft and shaft of the drive of driving wheels
11. Brake system
12. Suspension bracket
13. Steering and running gear
14. Body
15. Electric equipment
Schemes of electric equipment


Toyota RAV4>> Engines>> Repair of the engine 3S-FE without its removal from the car>> Final collector
Removal
You carry out removal of a final collector on the cold engine in the following order:
– switch off ignition and disconnect a wire of "weight" from the rechargeable battery;
– release from oxygen sensor wire clips. If the new final collector is established, remove the oxygen sensor.

Fig. 3.8. Arrangement of bolts of fastening of the thermofilter of a final collector


– turn out bolts (fig. 3.8) and remove the thermofilter of a final collector;
– apply the means facilitating them an otvorachivaniye on nuts of fastening of a final collector;
– disconnect a reception exhaust pipe from a final collector;

Fig. 3.9. An arrangement of a nut and a bolt of fastening of a support of a final collector about a forward support of the engine


– turn out nuts and bolts (fig. 3.9) and remove a support of a final collector. On some models about two support of a final collector are established;

Fig. 3.10. An arrangement of nuts of fastening of a final collector to a head of the block of cylinders


– turn out nuts (fig. 3.10) and remove a final collector and laying.
Installation
You make installation in the following order:
– remove with a scraper the remains of old laying and adjournment of soot from privalochny surfaces of a final collector and a head of the block of cylinders;
– establish new laying of a final collector on hairpins of a head of the block of cylinders;
– establish a final collector and fix it by nuts. Tighten nuts in several approaches, since the center and further on a spiral.
Further installation is carried out to the sequences, the return to removal.
Launch the engine and check for lack of leak of the fulfilled gases.