Use only the fresh DOT 4 brake fluid.
Uncover a tank with brake fluid.
The syringe pump out brake fluid from a tank.
Fill a tank with fresh brake fluid to exclude hit of air in the brake system from a tank. You watch that the level of brake fluid was in a tank not below the mark MIN during a procedure.
You make replacement of brake fluid for each branch hydraulic the doghouse in the same sequence, as removal of air.
Remove a dustproof cap from the union of pumping of a forward left support, clear it and put on it one end of a pure transparent hose, lower other its end in the capacity which is partially filled with brake fluid. Capacity has to be not less than 300 mm above the pumping union. Thanks to it hit of air in a support through a pumping union carving is prevented.
Sharply press a pedal of a brake of 3-5 times with an interval 2–3 with, turn out half way the pumping union at the pressed pedal. Continuing to press a pedal, force out the old brake fluid which is in a contour through a hose in capacity. After the pedal reaches extreme lower situation and the liquid effluence through a hose will stop, wrap the pumping union to the full. Release a brake pedal that she returned to a starting position.
Repeat these operations until of the union of pumping goes out fresh brake fluid.
During operations on replacement of brake fluid you watch the level of brake fluid in a tank.
Holding a pedal in the pressed situation, wrap the pumping union against the stop and remove a hose.
Wipe the union of pumping and establish a protective cap.
The recommended frequency: each 50 000 km of a run or 24 months.
On cars, since 2001, the fuel filter is an integral part of the block of the fuel pump installed in the fuel tank. Its periodic replacement is not provided.
Repeat these operations for hydraulic contours of other wheels.